Submenu Function
Display
You can make settings related to the projector's display.
Menu Position: Select the position to display the menu on
the projected screen.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect is
changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
*
: You can set the screen background
to Black, Blue, or Logo when no image signal is available.
Startup Screen
*
: Set to On to display the User's Logo when
projection starts.
A/V Mute
*
: You can set the screen displayed when
the [A/V Mute] button is pressed to Black, Blue, or
Logo.
Air Filter Notice: You can set whether or not (On/Off) to
enable Air Filter Notice. When this is set to On and a clog
in the air filter is detected, the message is displayed on the
screen.
Screen: (This setting is unavailable when projecting images
from a computer over a network.) Set the aspect ratio and
position of the projected screen according to the type of
screen being used.
s
"Screen Settings" p.19
Panel Alignment: Correct color misalignments (red and
blue) in the screen.
s "Panel Alignment" p.121
Color Uniformity: Adjusts the color tone balance for the
whole screen.
s "Color Uniformity" p.122
User's Logo
*
You can change the user's logo that is displayed as a
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo" p.58
Submenu Function
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button for about five seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
List of Functions
79
To Next Page
Loading...
Need help?
General
