Projector Network Settings - Network Menu
142
Setting Options Description
EAP Type EAP Type: selects the protocol for
authentication.
• PEAP: authentication protocol widely
used in Windows Server.
• PEAP-TLS: authentication protocol
used in Windows Server. Select this
when using a client certificate.
• EAP-TLS: authentication protocol
widely used to use a client certificate.
• EAP-FAST: select this when these
authentication protocols are used.
User name User name: Enter up to 64 alphanumeric
characters. You can enter up to 32
alphanumeric characters in the projector
menu. To enter more than 32 characters,
use your Web browser. You can enter a
domain name by adding it before the
user name and separating them with a
backslash (domain\username).
When importing a client certificate, the
name the certificate was issued to is
automatically set.
Password Password: Enter a password up to 64
alphanumeric characters for
authentication when EAP Type is set to
PEAP or EAP-FAST. You can enter up
to 32 alphanumeric characters in the
projector menu. To enter more than 32
characters, use your Web browser. After
you enter the password and select Set,
the password is displayed as an asterisk
(*).
Client Certificate Client Certificate: imports the client
certificate when EAP Type is set to
PEAP-TLS or EAP-TLS.
Verify Server Cert. Verify Server Cert.: Set to On to verify
the server certificate when a CA
certificate has been set.
Setting Options Description
CA certificate CA certificate: imports the CA
certificate.
RADIUS
Serv.Name
RADIUS Serv.Name: Enter the server
name you want to verify. You can enter
up to 64 alphanumeric characters. To
enter more than 32 characters, use your
Web browser.
Channel Various channels
available
In Quick connection mode, selects the
frequency band (channel) used by the
wireless LAN.
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
DHCP: set to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP
Address, Subnet Mask, and Gateway
Address using 0 to 255 for each address
field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
SSID Display On
Off
Select whether to display the SSID on the
network standby screen and Home
screen.
IP Address Display On
Off
Select whether to display the IP address
on the network standby screen and
Home screen.
IPv6 Settings Select the IPv6 settings if you want to
connect the projector to the network
using IPv6:
IPv6 IPv6: set to On if you want to connect
the projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
To Next Page
Loading...
Need help?
General
