Epson EF-100W - Adjusting a Fuzzy or Blurry Image; Fixing Partial Image Problems; Adjusting an Image that Contains Noise or Static

Solving Image Problems
79
b
Adjust the image shape using the Keystone settings.
s Settings > Keystone > H/V-Keystone
s Settings > Keystone > Quick Corner
gg Related Links
• "Projector Feature Settings - Settings Menu" p.61
• "Correcting the Image Shape with the Keystone Button" p.33
• "Correcting the Image Shape with Quick Corner" p.34
Adjusting a Fuzzy or Blurry Image
If the projected image is fuzzy or blurry, try the following steps until the
problem is solved.
a
Adjust the image focus using the focus lever.
b
Check the following items:
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so
wide that it distorts the image.
c
Clean the projection window.
a
To avoid condensation on the lens after bringing the projector in
from a cold environment, let the projector warm up to room
temperature before using it.
d
Adjust the Sharpness setting in the projector's Image menu to improve
image quality.
e
If you are projecting from a computer, use a lower resolution or select a
resolution that matches the projector's native resolution.
gg Related Links
• "Image Quality Settings - Image Menu" p.60
• "Focusing the Image Using the Focus Lever" p.36
• "Cleaning the Projection Window" p.69
Fixing Partial Image Problems
If only a partial computer image is displayed, try the following steps until the
problem is solved.
a
If you zoomed into or out of the image using the Zoom setting, press
the button until the projector returns to a full display.
b
Make sure you selected the correct projection mode. You can select this
using the Projection setting in the projector's Settings menu.
s Settings > Installation > Projection
c
Check your computer display settings to disable dual display and set the
resolution within the projector's limits. (See your computer manual for
details.)
gg Related Links
• "Projector Feature Settings - Settings Menu" p.61
Adjusting an Image that Contains Noise or Static
If the projected image contains electronic interference (noise) or static, try the
following steps until the problem is solved.
a
Check the cables connecting your video source to the projector. They
should be:
• Separated from the power cord to prevent interference
• Securely connected at both ends