Epson EH-TW5650 - Correct Manually (Quick Corner)

Basic Operations
32
Correct manually (Quick Corner)
You can use the projector's Quick Corner setting to correct the shape and size of an image that is unevenly
rectangular.
a
Press the button to display menus
in the order Settings - Keystone.
Remote control Control panel
b
Use the button to select
Quick Corner, and then press the
button. Press the button again if
necessary.
The area selection screen is displayed.
c
Select the corner you want to correct
using the
buttons,
and then press the
button.
c
To reset the Quick Corner
corrections, hold down the
button for about two
seconds while the area selection
screen is displayed, and then
select Yes.
d
Use the buttons to
adjust the position of the corner. Press
the
button to return to the area
selection screen.
c
If you see this screen, you cannot
adjust the shape any further in
the direction indicated by the
gray triangle.
e
Repeat steps 3 and 4 as needed to
adjust any remaining corners.
f
When you are finished, press the
button.
c
After executing Quick Corner,
the Keystone setting is now set
to Quick Corner in the
projector's Settings menu.
When you press one of the
buttons on the control
panel, the area selection screen
is displayed.