EasyManua.ls Logo

Epson EH-TW5650 - Other Problems

Epson EH-TW5650
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
88
Check Remedy
Does the device support copyright protection
(SCMS-T)?
You cannot connect a Bluetooth device that does not support
copyright protection (SCMS-T).
Is the device based on A2DP? You cannot connect a Bluetooth device that does not support
A2DP.
The audio and connection for the Bluetooth device disconnects
Check Remedy
Are there any obstacles between the projec-
tor and the Bluetooth device?
Check for any obstacles between the projector and the Bluetooth
device, and change their positions to improve communication.
Is the device connected within the specified
communication distance?
If the distance between the projector and the Bluetooth device
exceed 10 m, the connection may be lost. Move the Bluetooth
device closer to the projector.
Are there any wireless equipment or micro-
wave ovens in the vicinity?
If the device is used at the same time as other wireless equipment
or microwave ovens, radio wave interference may occur, and the
image and audio may be interrupted. Avoid equipment that
could cause interference.
Other problems
No audio, or the audio is too low
Check Remedy
Is the volume too low? Adjust the volume so that you can hear the audio. s p.33
Is it connected with an HDMI cable? If no audio is output when connecting via an HDMI cable, set the
connected equipment to PCM output.
Are the Audio Out Device settings correct? Check that the Audio Out Device settings are correct on the
Configuration menu.
s Settings - HDMI Link - Audio Out De-
vice p.68
Are the Bluetooth Audio settings correct?
Make the following settings when connecting a Bluetooth audio
device.
To output audio from the projector's speaker or an AV system,
set Bluetooth Audio to Off.
To output audio from Bluetooth audio devices, set Bluetooth
Audio to On.
s Settings - Bluetooth - Bluetooth Audio p.68
Cannot make settings on the control panel
Check Remedy
Is Control Panel Lock set to Full Lock or Par-
tial Lock?
When Control Panel Lock is set to Full Lock in the Configura-
tion menu, all button operations on the control panel are disa-
bled; when Partial Lock is set, only the
button on the control
panel is available. Perform operations from the remote control.
s Settings - Lock Setting - Control Panel Lock p.68

Table of Contents

Related product manuals