Maintenance
110
d
Loosen the two lamp fixing screws.
e
Remove the old lamp.
Raise the handle on the lamp, and then pull
it straight up.
f
Install the new lamp.
Insert the lamp in the correct direction, and
then lower the handle.
g
Tighten the two lamp fixing screws.
h
Replace the lamp cover.
Slide the cover back into place.
i
Tighten the lamp cover fixing screw.
Warning
Do not disassemble or remodel the lamp. If a modified or disassembled lamp is installed in the projector
and used, it could cause a fire, electric shock, or an accident.
Caution
•
Make sure you install the lamp and lamp cover securely. If they are not installed correctly, the power does
not turn on.
•
The lamp contains mercury (Hg). Dispose of used lamps in accordance with your local laws and regulations
on disposing of fluorescent tubing.
Resetting lamp hours
After replacing the lamp, make sure you reset the lamp hours.
To Next Page
Loading...
