SelecType Problems
Problem
Solution
SelecType does not
function as expected
(continued).
After changing
printer modes, you
find that your
previous SelecType
Level 2 settings for
that mode have
changed.
You may be trying to set up different
SelecType Level 2 configurations for a
number of printer modes. This is not
possible because SelecType Level 2 settings
are not specific to a particular printer
mode. For example, if you change the I/F
setting from PARALLEL to SERIAL in one
mode and save it with P-CONFIG SAVE,
the change is reflected in all printer modes.
However, you can have up to four separate
configurations for SelecType level 1
settings and save them as macros.
7-30
Troubleshooting
To Next Page
Loading...
