Plugging in the Scanner
1. Connect the power cable to the power inlet on the rear of the
scanner and plug the other end into a properly grounded
outlet as shown below.
c
Caution:
There are several versions of this scanner designed for
different voltages, and it is not possible to change the
voltage. If the label on the back of the scanner does not
show the correct voltage for your country, contact your
dealer.
2. If any of the scanner’s lights come on, press the
OPERATE
button to turn the scanner off.
c
Caution:
Whenever you turn off the scanner, wait at least 10
seconds before turning it back on. Rapidly turning it on
and off can damage the scanner.
1-2
1-3
L
Ginger Rev.C
A5 size Chapter 1
97/07/23 Pass 1, DR
1-4
Setting Up the Scanner
To Next Page
Loading...
