Epson GT-12000 - Chapter 2 Scanner Basics; Lights and Buttons; Scanner Basics

Lights and Buttons
The scanner has three indicator lights and two buttons.
OPERATE light (green)
Comes on when the scanner is turned on.
READY light (green)
Comes on when the scanner is ready to scan images. This
light flashes during scanning. When an error occurs, the
combination of this light and the ERROR light indicate the
type of error as shown in the table on the next page.
ERROR light (red)
Comes on when an error occurs. Along with the READY light,
this light indicates the type of error.
OPERATE button
Turns the scanner on and off.
RESET button
Returns the scanner to operating status after an error occurs.
ERROR light
READY light
OPERATE light
OPERATE button
RESET button
01-04
L
Ginger Rev.C
A5 size Chapter 2
97/07/23 Pass 2, DR
2-2
Scanner Basics