GT-30000
A5-Format Quick Start Manual_E.fm
1/11/01 Right
R
13
EN
❚ Setting the select switch
The scanner has two SCSI connectors: one is for a wide 68-pin SCSI cable and the other
for a narrow 50-pin SCSI cable. You may need to change the select switch setting
according to the SCSI cable you are using.
The terminator switch is located
at the rear of the scanner.
Only the scanner is connected
terminator on
(other SCSI device)
terminator on
The scanner is the last device in the daisy chain
The scanner is in the middle of the daisy chain
terminator off
(other SCSI device)
To Next Page
Loading...
