Epson L800 - Page 37

L800/L801 Revision A
Disassembly/Reassembly Removing the Printer Mechanism 36
Confidential
2. Release the Waste Ink Tube from the groove of the Waste Ink Tray.
3.
Release the CR Motor Cable from the two ribs of the Waste Ink Tray.
Figure 1-44. Removing the Printer Mechanism (1)
4. Disconnect the connector of the CDR Guide Sensor.
Figure 1-45. Removing the Printer Mechanism (2)
5. Remove the five screws and remove the Printer Mechanism.
Screw : C.B.P.(P2) M3x8 (tightening torque:5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 1-46. Removing the Printer Mechanism (3)
CR Motor Cable
Waste Ink Tube
Waste Ink Tray
Waste Ink Tube
CDR Guide Sensor
CDR Guide Sensor Cable Opening
4
5
2
3
1
Positioning Hole and
Guide Pin