L800/L801 Revision A
Disassembly/Reassembly CR Motor 50
Confidential
1.5.12 CR Motor
¸ Removal procedure
1. Remove the Extension Spring of the Driven Pulley Assy from the rear side.
Figure 1-84. Removing the Extension Spring
2. Remove the Driven Pulley Assy and remove the Timing Belt from the Pinion
Gear of the CR Motor.
Figure 1-85. Removing the CR Motor (1)
3. Release the connector cables from the three hooks, then peel off the three
acetate tapes to release the CR Motor cable.
Figure 1-86. Removing the CR Motor (2)
4. Insert a Phillips screwdriver (with a shaft of 13cm or longer is recommended)
through the hole of the Front Frame, remove the two screws, and remove the
CR Motor.
• Screw : C.P. M3x4 (tightening torque: 3-5 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 1-87. Removing the CR Motor (3)
C A U T I O N
Take extra care not to contaminate the Timing Belt with grease.
The belt deteriorates faster if grease adheres to it.
Driven Pulley Assy
Extension Spring
[Rear Side]
[Rear Side]
Driven Pulley Assy
Pinion GearTiming Belt
C A U T I O N
When assembling or disassembling the CR Motor, be careful of the
three sharp hooks of the Main Frame shown in Fig.1-86.
: Hook
CR Motor
CR Motor Cable
[Rear Side]
1
2
CR Motor
To Next Page
Loading...
