Epson L800 - Stacker Assy; Stacker Cover; Housing Upper Assy

L800/L801 Revision A
Disassembly/Reassembly Stacker Assy / Stacker Cover 25
Confidential
1.3.3 Stacker Assy / Stacker Cover
¸ Removal procedure
1. Open the Stacker Cover.
2. Remove the Stacker Assy.
3. Release the Stacker Cover from the two shafts and remove the Stacker Cover.
Figure 1-18. Removing the Stacker Assy / Stacker Cover
1.3.4 Housing Upper Assy
¸ Removal procedure
1. Remove the four screws and remove the Upper Housing upward.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 1-20. Removing the Upper Housing
When installing the Stacker Assy, insert the guide pins of the
Stacker Assy into the lower grooves of the Guide Stacker Assy.
(The upper grooves are used when CDR is printed.)
Figure 1-19. Installing the Stacker Assy
Stacker Assy Stacker Cover
Shaft
Shaft
Groove
Guide Pin
Guide Pin
Groove
[Rear Side]
3
4
Groove
Groove
1 2
Upper Housing