Epson L800 - Problems and Solutions

L800/L801 Revision A
Disassembly/Reassembly Joint 65
Confidential
1.6.8 Joint 1.6.9 Cover Case
 Make sure the red lines of the Ink Supply Tank Tube and Ink Supply Tube facing
upward.
 When attaching the Joint, align the cutout of the Joint with the rib of the Cover Case.
 Make sure the gaps between the end of Ink Supply Tank Tubes or Ink Supply Tubes
and the Joint are 0.5 mm long or less.
0.5 mm or less
Ink Supply Tube
Ink Supply Tank Tube
Joint
0.5 mm or less
Front
Adapter Side
Tank Side
Joint
Back
Adapter Side
Tank Side
Joint
Joint
Rib
Ink Supply Tube
Cover Case
Joint
Cutout
Be careful not to damage the Cover Case with the edges of the front frame.
Follow the procedure below when removing the Cover Case.
1. Remove the screw (x1).
2. Lift the Cover Case slightly to release the dowels (x2) on the bottom of the Cover
Case.
3. Rotate the Cover Case in the direction of the arrow (1) to avoid the section A and B of
the Cover Case from bumping against the Front Frame.
4. Remove the Cover Case in the direction of the arrow (2) while avoiding the section C
of the Cover Case from bumping against the Front Frame.
Section A
Section B
Cover Case
Section C
C.B.P. 3X8 (5-7kgf.cm)
Cover Case
Cover Case
Front Frame
Front Frame
Dowel
1
1
2
The location where Front Frame may interfere.
The location where Front Frame may interfere.