Epson L800 - Waste Ink Tray

L800/L801 Revision A
Disassembly/Reassembly Waste Ink Tray 42
Confidential
1.5.5 Waste Ink Tray
¸ Removal procedure
1. Remove the two screws, disengage the hook, and remove the Waste Ink Tray.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
Figure 1-63. Removing the Waste Ink Tray
3. Install the APG Unit to the Main Frame.
Figure 1-61. Reinstalling the APG Unit (3)
4. Check that the hooks ( ) are attached to the positioning
holes of the Main Frame, then screw the APG Unit.
Figure 1-62. Reinstalling the APG Unit (4)
 Tighten the screws in the order given in
Fig.1-57 (p.41).
APG UnitPin
Main Frame
C A U T I O N
When removing the Waste Ink Tray, take extra care not to spill
ink and contaminate the printer and surroundings.
A D J U S T M E N T
R E Q U I R E D
Whenever the Waste Ink Tray is replaced, the required
adjustments must be carried out.
•
Refer to "2.1.2 Required Adjustments" (p.74)
Waste Ink Tray
Hook