Epson LQ-670 - DETECTOR, PE, REAR Removal

LQ-670 Service Manual
Rev. A
3-26
3.2.20 DETECTOR, PE, REAR Removal
1. Remove the Printer Mechanism (See Section 3.2.2)
2. Unhook three tabs of [HOLDER, CABLE, LOWER] at the bottom of the Printer
Mechanism, and remove it from the Printer Mechanism.
3. Remove a screw (CBS/M3x6) fixing [DETECTOR, PE. REAR].
4. Remove the detector holder from [FRAME, BASE] by unhooking the fixing tabs and
remove it.
5. Unhook [DETECTOR, PF, REAR] from the holder and remove it.
DETECTOR, PE, REAR
Figure 3-27. DETECTOR, PE, REAR Removal