Epson LQ-670 - LEVER, RELEASE Removal

Chapter 3 Disassembly and Assembly
Rev. A
3-2
7
3.2.21 LEVER, RELEASE Removal
1. Remove the Printer Mechanism (See Section 3.2.2)
2. Remove two E-shaped retaining rings (#4) that fixing [LEVER, RELEASE] to [FRAME
ASSY., RIGHT].
3. Remove [LEVER, RELEASE] from [FRAME ASSY., RIGHT], together with
[COMBINATION GEAR, 16, 16].

Be careful not to lose [GEAR, 20] and a washer when removing [LEVER, RELEASE]
as they may be popped out by [COMPRESSION SPRING, 20].
 Make sure that [GEAR, 20] moves smoothly when moving [LEVER, RELEASE].
 Make sure to match the position marking on [LEVER, RELEASE] and
[COMBINATION GEAR, 16, 16], as shown in figure below, when reinstalling
[LEVER, RELEASE].
CHECK POINT
COMBINATION GEAR, 16,16
SPUR GEAR, 20 (White)
SPUR GEAR, 20 (Black / for Tractor)
COMPRESSION SPRING, 1.96
Washer
GEAR, 20 (Black)
LEVER, RELEASE
Retaining Ring
(E-shape)
Figure 3-28. LEVER, RELEASE Removal
COMBINATION GEAR, 16,16
LEVER, RELEASE
F
T
F
T
COMBINATION GEAR, 16,16
LEVER, RELEASE
Figure 3-29. LEVER, RELEASE Installation