Epson LQ-670 - Cut-Sheet Feeders

Chapter 4 Adjustments
Rev. A
4-
3
4.2.2 Factory Setting
1. Unplug the cable of the printer from the AC socket.
2. Connect the printer and the PC by the parallel interface cable.
3. Plug in the cable of the printer and turn on the printer.
4. Set the release lever at the tractor side and also set the 12-inch continuous paper (1p).
5. Load “GWBASIC” and execute the adjustment program. Following menu will be displayed.
3URJUDP/4D 6HWWLQJ
95 95 95 
✼✼ ✼ ✼
>3ULQWVHOHFW@
 SLQV
! SLQV
6. In this menu, select 24 pins by moving the cursor with the ↑ or ↓ and press ENTER key. After 24 pins
is selected, the following Setting file menu for default setting is shown.
3URJUDP/4D 6HWWLQJ
SLQV95 95 95 
✼✼✼✼
>6HWWLQJILOH@
!'()67' ,7$/,&
 86$67'
 (8567'
 1/63
 5866,$1
In this Menu, select DEFSTD by moving the cursor with the ↑or ↓ and press ENTER key.
After the default setting, following menu will be displayed.
3URJUDP/4D 6HWWLQJ'()67'
SLQV95 95 95 
✼✼ ✼ ✼
[ 3URFHVVVHOHFW@
 ! ,QOLQH
2XW*RLQJ
Destination Destination Code Destination Destination Code
EUL(Middle East), Japan DEFSTD EDG(NLSP) NLSP
EAI, EAI(Latin), EAL,
ESP, EHK, ETT
USASTD -- RUSSIA
Europe Standard, EDG,
EUL(Nordic), EFS, EIS,
EBS
EURSTD -- ITALIC
8. In this Menu, select In line by moving the cursor with the ↑or ↓ and press ENTER key.
After the selection is made, the following menu is displayed.
3URJUDP/4D 6HWWLQJ'()67'
SLQV95 95 95 
✼✼,QOLQH✼✼
>&DUULDJH:LGWK@
 ! FROXPQ
FROXPQ
Table 4-3. Destination Setting