AGM (Alternate Graphics Mode)
When AGM is on, the printer can use advanced graphics
commands like those available in ESC/ P 2 mode. This feature is
available only in IBM emulation mode. The default setting is Off.
Fon t
In the default-setting mode, you can select from these six fonts:
OCR-B, Orator, Orator-S, S
cript C, Roman T, and S
ans Serif H.
The following additional fonts are available only by pressing
the
Fo nt
button on the control panel: Draft, Roman, Sans Serif,
Courier, Prestige, and Script. You cannot select the control
panel fonts in the default-setting mode.
Changing the default settings
Follow the steps below to enter the default-setting mode and
change the printer’s default settings.
Note:
❏
To print the language selection sheet and the default-setting
mode instruction sheets, you need four sheets of A4 or letter
size single-sheet paper or 11-inch or longer continuous paper.
See Chapter 3, “Paper Handling,” for instructions on loading
single-sheet and continuous paper.
❏
If you use single-sheet paper to print the default-setting mode
instruction sheets, be sure to load a new sheet of paper each time
the printer ejects a printed sheet. Otherwise, you cannot proceed
to the next step.
L
Adonis Rev.C
A5 size Chapter 4
96/12/ 19 pass 5
4-14
Using the Control Panel
To Next Page
Loading...
