Epson LQ-670 - Adjusting the Tea R-Off Position

Adjusting the tear-off position
If your paper perforation is not aligned with the tear-off edge,
you can use the micro-adjust feature to move the perforation to
the tear-off position as follows:
1. Make sure both
Tear Off/Bin
lights are flashing (the paper
is at the current tear-off position). You may need to press
the
Tear Off/Bin
button.
2. Hold down the
Pa use
button for about three seconds.
The
Pa use
light begins flashing and the printer enters
the micro-adjust mode.
A35-2
3
R
Adonis Rev.C
A5 size Chapter 3
96/12/ 19 pass 5
Paper Handling
3-31