Epson LX-1170 User Manual

4-6
Troubleshooting
The print is faint or uneven
The printer makes a strange noise, the beeper sounds five
times, and the printer stops abruptly.
The paper or ribbon may be jammed. Turn off the printer and check
for a paper jam, a ribbon jam or other problems.
The printer may have overheated. Let the printer cool. Then try to print
again. If the printer still does not print correctly contact your dealer.
The beeper sounds five times and the PAUSE light comes on.
An error has occurred. Turn off the printer and turn it on again. If the
PAUSE light stays on, check for a paper jam or ribbon jam. If there is
no jam, contact your dealer or a qualified service person. (If an error
occurs when you switch between single sheets and continuous paper,
make sure the paper-release lever is in the correct position.)
Printed characters have parts missing at the bottom.
The ribbon cartridge may not be installed properly. See “Installing or
replacing the ribbon cartridge” on page 1-9.
The printout is faint.
The ribbon may be worn out. Replace the ribbon cartridge as described
under “Installing or replacing the ribbon cartridge” on page 1-9.

Epson LX-1170 Specifications

Print Speed

high speed draft 15 CPI	337 cps
high speed draft 12 CPI	337 cps
high speed draft 10 CPI	300 cps
high speed draft 20 CPI condensed	300 cps
high speed draft 17 CPI condensed	321 cps

Power

rated voltage	AC 120V or AC 220~240V
rated frequency	50~60Hz
power consumption	23W

Environmental Conditions

temperature	5~35˚C
humidity	10~80% RH
acoustic noise	49dB (A)

Reliability

MVBF (Mean Print Volume Between Failure)	12 million lines
MTBF (Mean Time Between Failure)	6000 POH
print head life	400 million strokes/ wire

Weight and Dimensions

width	546 mm
depth	275 mm
height	163 mm
weight	6.3 kg