Epson LX-1170 User Manual

Troubleshooting
4-11
4
Options
When you use the cut-sheet feeder, the paper
does not feed properly
The paper does not feed.
The cut-sheet feeder may be incorrectly installed on the printer.
Reinstall it as described under “Cut-sheet feeder” on page 2-33.
Make sure the paper-release lever is pushed back to the single-sheet
position.
You may have loaded too many sheets in the cut-sheet feeder’s bin.
Paper may be jammed near the print head. Look for a paper jam.
Make sure the edge guide positions are correct. Position the edge
guides at the diamond-shaped guide marks.
There may be only one sheet left in the bin. Add more paper.
Two or more sheets feed at one time.
You may have loaded too many sheets in the cut-sheet feeder’s bin.
You may have forgotten to fan the stack of paper before loading it into
the bin. Remove the paper and fan it.
The paper feed is crooked.
The paper may be old or creased. Use only new, clean sheets of paper.
There may be too much paper in the stacker.
Make sure that the paper guides are set correctly and that your paper
is the proper size and quality. See “Printer Specifications” on page A-4
for paper specifications.

Epson LX-1170 Specifications

Print Speed

high speed draft 15 CPI	337 cps
high speed draft 12 CPI	337 cps
high speed draft 10 CPI	300 cps
high speed draft 20 CPI condensed	300 cps
high speed draft 17 CPI condensed	321 cps

Power

rated voltage	AC 120V or AC 220~240V
rated frequency	50~60Hz
power consumption	23W

Environmental Conditions

temperature	5~35˚C
humidity	10~80% RH
acoustic noise	49dB (A)

Reliability

MVBF (Mean Print Volume Between Failure)	12 million lines
MTBF (Mean Time Between Failure)	6000 POH
print head life	400 million strokes/ wire

Weight and Dimensions

width	546 mm
depth	275 mm
height	163 mm
weight	6.3 kg