10 Introduction
When maintaining the printer
❏ Unplug the printer before cleaning it, and always clean it
with a damp cloth only.
❏ Do not spill liquid onto the printer.
❏ Except as specifically explained in this manual, do not
attempt to service the printer yourself.
❏ Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
i. If the power cord or plug is damaged.
ii. If liquid has entered the printer.
iii. If the printer has been dropped or the cabinet damaged.
iv. If the printer does not operate normally or exhibits a
distinct change in performance.
❏ Do not use aerosol blowers which contain flammable gas
inside or around this product. Doing so may cause fire.
❏ Adjust only those controls that are covered by the operating
instructions.
To Next Page
Loading...
Need help?
General
