Paper Handling 23
Note:
❏ The printer has a minimum and a maximum top-of-form
position. If you try to adjust it beyond these limits, the printer
beeps and stops moving the paper.
❏ When the paper reaches the default top-of-form position, the
printer beeps and stops moving the paper briefly. You can use
the default position as a reference point when adjusting the
top-of-form position.
5. After you set the top-of-form position, press the Pause
button to exit Micro Adjust mode.
Note:
❏ Your top-of-form position setting remains in effect until you
change it, even if you turn off the printer.
❏ The top margin setting made in some software applications
overrides the top-of-form position setting you make with the Micro
Adjust feature. If necessary, adjust the top-of-form position in
your software.
❏ If you want to restore the printer’s default top-of-form position,
you can reset the printer. See page 73 for instructions.
Advancing paper to the tear-off edge
When the push tractor is installed, you can use the tear-off
feature to advance your continuous paper to the printer’s tear-
off edge when you finish printing. You can then easily tear off
the printed document. When you resume printing, the printer
automatically feeds the paper back to the top-of-form position;
so you can save the paper normally lost between documents.
To Next Page
Loading...
Need help?
General
