Maintenance and Troubleshooting 77
Using the error indicators
If your printer stops working and one or more control panel
lights are on or flashing or the printer beeps, use the following
table to diagnose and fix the problem. If you cannot fix your
problem using this table, go to the next section.
Panel light
state
Beep
pattern
Problem
Solution
n Pause – The printer is paused.
Press the Pause button to resume printing.
••• Paper from another paper source is
currently in the paper path.
Move the paper release lever to the
correct position and press the Load/Eject
button to clear the paper from the paper
path. Then set the lever to the position
you want to use. Press the Pause button to
turn off the Pause light, if necessary.
n Paper Out
n Pause
••• No paper is loaded in the selected paper
source.
Load paper in the printer. Then press the
Pause button to turn off the Pause light, if
necessary.
••• The paper is not loaded correctly.
Remove your paper and reload it. Then
press the Pause button to turn off the
Pause light, if necessary.
••• Paper is jammed in the printer.
Turn off the printer and open the printer
cover, tear off the paper supply, and turn
the paper feed knob to eject the
remaining paper.
To Next Page
Loading...
Need help?
General
