Epson Perfection 1270 - Removal of I;F Board

EPSON Perfection 1670 Photo/Perfection 1270 Revision B
DISASSEMBLY/ASSEMBLY Disassembly Procedure 18
2.2.3 Removal of I/F Board
1. Remove the Upper Housing. (Refer to 2.2.2)
2. Disconnect the CR Motor Connector Cable and Panel FFC from the I/F Board.
3. In the order shown in Figure 2-10, unlock the Harness Locking Mechanism and
disconnect the Carriage FFC from the I/F Board.
4. Remove the three screws (CBP M3x8) shown in Figure 2-11, and remove the
following parts.
1. Shield Plate for I/F Board (Upper side)
2. I/F Board
3. Shield Plate for I/F Board (Lower side)
Figure 2-9. Disconnection of CR Motor Connector Cable and Panel FFC
Figure 2-10. Disconnection of Carriage FFC
Figure 2-11. Removal of I/F Board
CR Motor Connector Cable
Panel FFC
I/F Board
Carriage FFC
Step 3-1)
Step 3-1)
Step 3-2)
CBP (M3x8)
Tightening torque 6-8kgfcm
Shield Plate for I/F Board (Lower side)
Shield Plate for I/F Board (Upper side)
I/F Board