Epson Perfection 1270 - Removal of TPU Inverter Board

EPSON Perfection 1670 Photo/Perfection 1270 Revision B
DISASSEMBLY/ASSEMBLY Disassembly Procedure 26
2.2.8 Removal of TPU Inverter Board
1. Remove the TPU Unit. (Refer to 2.2.1)
2. Slide the Housing Mat to the front to remove it from the sockets of the TPU Unit, and
remove the Housing Mat.
3. Remove the six screws (four (CBP M3x8), two (CBB M3x12)) shown in Figure 2-27
that are securing the TPU Inverter Unit, and remove the TPU Inverter Unit.
Figure 2-26. Removal of Housing Mat
Figure 2-27. Removal of TPU Inverter Unit
Housing Mat
SocketsSockets
CBB (M3x12)
Tightening torque 6-8kgfcm
TPU Inverter Unit
CBP (M3x8)
Tightening torque 6-8kgfcm