26
Adjusting the Display
Adjusting the projection angle
1 Set up the projector so that it is at right angles to the screen.
If it is not possible to set up the projector so that it is at right angles to
the screen, it can be set up at a slight vertical angle instead. (Max
10°)
2 Raise the front of the projector while pressing the buttons on
both sides.
3 Extend the front feet and release the buttons when the projector
is adjusted to the desired height.
Seen from the side
Center of
lens
Seen from above
p
• The height can be adjusted by turning the base of the front feet on
either side.
• Press the front buttons on both sides and slowly lower the projector
down to return to its normal position.
To Next Page
Loading...
