29
Functions for Enhancing Projection
Advanced Operation
Functions for Enhancing Projection
Adjusting computer generated images
The computer signal is analyzed and the following settings are adjusted to
ensure the optimum image quality.
◗ Tracking
g
◗ Position
◗ Sync.
g
When Auto setup is set to off, press the [Auto]
button on the remote control to perform auto
setup.
Adjust the Tracking and Sync settings manually if Auto setup cannot be
performed. ([Menu] button → “Image” → “Picture Quality” → “Tracking,”
“Sync.”) See “
Image menu” on page 36.
Selecting a color mode
There are five present color modes available for use. Make a selection
appropriate to the conditions in which you are projecting.
• Dynamic
Images are modulated and made crisper to emphasize brightness.
• Presentation
Brightness is emphasized. For presentations in bright rooms.
• Theatre
Best for watching movies in their natural tones.
• Living Room
Brightness is emphasized. Ideal for playing video games in bright
rooms.
• sRGBg
Conforms to the sRGB color standard. If the connected source has an
sRGB mode, set both the projector and the connected source to
sRGB.
p
You can set Auto setup to off in the “Image”
→
“Auto Setup”
configuration menu. (The default is ON) See “Image menu” on page 36.
p
If you press the [Auto] button during E-Zoom or Freeze operation, or
when a configuration menu is being displayed, the display will be halted
and auto setup will take place.
To Next Page
Loading...
Need help?
General