Exiting SETUP
When you leave SETUP, you can save your settings and reboot
your system, or exit SETUP without saving your settings. You
can also return all values to the factory defaults.
To leave SETUP, press
Esc
from any SETUP screen. From the
Exiting SETUP menu, you can press these keys:
Esc
Returns to SETUP
F4 Saves
the changes you have made to your
configuration and restarts your computer
F5
Supplies the factory default values for all options
F6
Exits SETUP and returns to the system prompt
without saving any changes.
Post-SETUP Procedures
After you run SETUP for the first time, you may need to install
the operating system if your system is not preconfigured. Make
sure your hard disk drive is partitioned and formatted for the
operating system you plan to install. See your operating system
manual for instructions.
Once you have installed your operating system, install any
software you plan to use. See your application program
manuals for instructions.
Setting
Up
Your System
1-19
To Next Page
Loading...
Need help?
General