Epson RC700 - Page 206

Maintenance 9. Troubleshooting
194 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
2243
Variable overflow. Specified
variable was beyond the maximum
allowed value.
Check the variable type and
calculation result. Review the
program.
2244
Variable underflow. Specified
variable was below the minimum
allowed value.
Check the variable type and
calculation result. Review the
program.
2245
Cannot execute this command with
a floating point number.
This command cannot be executed
for Real or Double type. Review the
program.
2246
Cannot calculate the specified
value using the Tan function.
Check the specified value. Review
the program.
The specified
value
2247
Specified array subscript is less
than ' 0 '.
Check the specified value. Review
the program.
The specified
value
2248
Array failure. Redim can only be
executed for an array variable.
You attempted to Redim the variable
that is not array. Rebuild the
project.
2249
Array failure. Cannot specify
Preserve for other than a single
dimension array.
Other than a single dimension array
was specified as Preserve for Redim.
Rebuild the project.
2250
Array failure. Failed to calculate
the size of the variable area.
Rebuild the project.
2251
Cannot allocate enough memory for
Redim statement.
Reduce the number of subscripts to
be specified for Redim. Perform
Redim modestly.
2252
Cannot allocate enough memory for
ByRef.
Reduce the number of array's
subscripts to be seen by ByRef.
2253
Cannot compare characters with
values.
Check whether the string type and
the numeric data type are not
compared. Review the program.
2254
Specified data is beyond the array
bounds. Cannot refer or update
beyond the array bounds.
Check the number of array's
subscripts and data. Review the
program.
The number
of array
subscripts
The number
of data to be
referred or
updated
2255
Variable overflow or underflow.
Specified variable is out of value
range.
The value that exceeds the range of
Double type is specified. Review
the program.
2256
Specified array subscript is beyond
the maximum allowed range.
Reduce the number of subscripts to
be specified. For available
subscripts, see the online help.
2257
Cannot specify Int64 variable or
UInt64 variable.
Int64 variable or UInt64 variable
cannot be specified. Correct the
program.
2260
Task number is out of the available
range.
For available task number, see the
online help. Review the program.
The specified
task number
2261
Specified task number does not
exist.
Review the program.
The specified
task number
2262
Robot number is out of the
available range.
The available Robot number is 1.
Review the program.
The specified
robot number
2263
Output number is out of the
available range. The Port No. or
the Device No. is out of the
available range.
For available output number, see the
online help. Review the program.
The specified
output
number