Epson RC700 - Page 240

Maintenance 9. Troubleshooting
228 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
3418 Axis is not specified.
Axis parameter is not specified in
Force_GetForce function or
Force_SetTrigger statement.
Refer to SPEL+ Language Reference
“Force_GetForce Function” and
specify a proper setting value.
3419 CompareType is not specified.
ComapreType parameter to set
judgment condition is not specified in
Force_SetTrigger statement.
Refer to SPEL+ Language Reference
“Force_SetTrigger Statement” and
specify a proper parameter.
3420
Integer or Short type array variable
is only available.
-
3421
Form name or window ID is not
specified.
Form name or system window ID
which is subject to operation is not
specified in GShow and GClose
statements. Specify a valid form
name or window ID. For details of
window ID, refer to GUI Builder7.0
manual “GShow Statement”.
3422 Window ID is not specified.
System window ID which is subject to
operation is not specified in GShow
and GClose statements. Refer to
GUI Builder7.0 manual “GShow
Statement” and specify a proper
window ID.
3423
Performance mode ID was not
specified.
Performance mode is not specified in
PerformMode parameter of
PerformMode statement, Go, BGo,
TGo, Jump statement. Refer to
SPEL+ Language Reference
“PerformMode” and specify a proper
performance mode.
3424 Protocol type was not specified.
Communication protocol setting is not
specified in SetNet statement.
Specify UDP or TCP.
3425
I/O type or I/O label was not
specified.
I/O type or I/O label is not specified in
IODef function. Specify the I/O label
or I/O type to check existence of
definition. For details of I/O types,
refer to SPEL+ Language Reference
“IODef Function”.
3426
Singularity avoidance mode was
not specified.
Singularity avoidance mode is not
specified in AvoidSingularity
statement. Refer to SPEL+
Language Reference
“AvoidSingularity Statement” and
specify a proper mode.
3427
Acceleration value was not
specified.
Setting number of acceleration is not
specified in AccelR function. Refer
to SPEL+ Language Reference
“AccelR Function” and specify a
proper setting value.