Epson RC700 - Page 248

Maintenance 9. Troubleshooting
236 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
3880
Cannot specify Force Coordinate
System Object label.
Review the program.
Force coordinate system object label
cannot be specified in FDel and FList
statements.
Correct the program.
3881
Cannot specify Force Control
Object label.
Review the program.
Force control object label cannot be
specified in FDel and FList
statements.
Correct the program.
3882
Cannot specify Force Monitor
Object label.
Review the program.
Force monitor object label cannot be
specified in FDel and FList
statements.
Correct the program.
3883
Cannot specify Force Trigger
Object label.
Review the program.
Force trigger object label cannot be
specified in FDel and FList
statements.
Correct the program.
3884
Cannot specify Force Sensor
Object label.
Review the program.
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
3885
Cannot specify Mass Property
Object number.
Review the program.
Mass property object number cannot
be specified in MPNumber function.
Correct the program.
3886
Cannot specify Force Coordinate
System Object number.
Review the program.
Force coordinate system object
number cannot be specified in
FNumber function.
Correct the program.
3887
Cannot specify Force Control
Object number.
Review the program.
Force control object number cannot
be specified in FNumber function.
Correct the program.
3888
Cannot specify Force Monitor
Object number.
Review the program.
Force monitor object number cannot
be specified in FNumber function.
Correct the program.
3889
Cannot specify Force Trigger
Object number.
Review the program.
Force trigger object number cannot
be specified in FNumber function.
Correct the program.
3890
Cannot specify Force Sensor
Object number.
Review the program.
-
3891
Type of the specified two objects
does not match.
Specify the same type of the
objects.
The data type of the first and the
second parameter does not match in
FDel, FList, MPDel, MPList
statements.
Correct the program.
3900
Cannot obtain the internal
communication buffer.
-
3901
Buffer size is not enough.
-
3910
Undefined command was
specified.
-
3911
Cannot enter the file name in the
file name buffer.
-
3912
Cannot obtain the internal buffer.
-
3913
Cannot set priority.
Reboot the controller.
3914 Invalid ICode.
Rebuild the project.
3915 Invalid ICode.
Rebuild the project.
3916 Invalid ICode.
Rebuild the project.