G
Pass film through the roll core.
H
Insert the roll core into the right-side media
holder.
I
Push the left-side media holder inwards, and
then tighten the locking screw.
J
Rotate the handle until part A in the illustration
below is fully inserted.
K
Move the film to the left side, insert its leading
edge into the printer, and pass it through to the
back side.
Insert it into the bottom of the dryer and then out
the top part, over the platen and through to the
back.
SC-F10000 Series User's Guide
Appendix
193
To Next Page
Loading...
Need help?
General