Epson SC-F10000 Series User Manual

Step and Repeat Process on the
Printer
Normally, when doing step and repeat printing,
printing is done while ripping the job created for the
repeated pattern, so Epson Edge Print and the RIP
server (computer on which Epson Edge Print is
installed) cannot be shut down until printing is
complete. With step and repeat processes on the printer,
once printing is started, Epson Edge Print and the RIP
server can be shut down while printing.
However, it is not possible to shift and position the
image, nor to specify the starting point of the pattern.
Select Execute Step and Repeat on the Printer, and set
the size of the area on which to place the image in Layout
Area Size.
Selecting Layout Area Size lines up and places the image
in the specified size.
If you select a Width for the Layout Area Size that is
wider than the media's width, the image that extends
beyond the media's width is not printed.
SC-F10000 Series User's Guide
Introduction
55

Epson SC-F10000 Series Specifications

General

Brand	Epson
Model	SC-F10000 Series
Category	Printer
Language	English