Epson SC-F10000 Series User Manual

D
Align and move the right-side media holder to
the right edge of the media.
E
While pressing from the top of the media holder,
tighten the fixing screw in place.
F
Insert the roll core onto the right-side media
holder.
G
Check that the left-side media holder is fully
inserted into the roll core and that the roll core
and edges of the media are not misaligned.
c
Important:
If the edges of the media are misaligned, the
media cannot be taken up correctly. If the
edges are misaligned, loosen the fixing screw
for the right-side media holder, and then
restart from Step 4.
H
To ensure that the media holder is sufficiently
inserted into the roll core, push the top of the
media holder towards the end of the roll two
times.
c
Important:
If the media holder is inserted into the roll core
insufficiently, media is not fed correctly during
printing because of slippage between the media
holder and roll core.
This may cause banding in the print results.
SC-F10000 Series User's Guide
Basic Operations
76

Epson SC-F10000 Series Specifications

General

Brand	Epson
Model	SC-F10000 Series
Category	Printer
Language	English