I
While pressing from the top of the media holder,
tighten the fixing screw.
Tighten it so the media holder does not move.
J
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the media holder.
If part A is still visible even after the handle has
been turned fully, rewind the handle. Loosen
the media holder screw on the right side, and
then restart from Step 5.
K
Leave a 10 to 20 cm wide section in the center of
the media, and cut at least 25 cm in height from
the left and right corners of the media.
Cutting the media prevents feeding problems,
such as the left and right corners of media being
folded and caught at the start of take-up.
Next, see the following according to the procedure.
Normal feeding procedure U “Take-up with the
Normal Feeding Procedure” on page 78
Take-up feeding procedure U “Take-up with the
Take-Up Feeding Procedure” on page 80
SC-F10000 Series User's Guide
Basic Operations
77
To Next Page
Loading...
Need help?
General