D
Load the paper with the side you want to print on
facing forward, and the edge aligned with the line
on the right.
Normally, the paper should be loaded vertically.
You can load thick paper with a length of up to
762 mm. However, you can load thick paper that
is longer than 762 mm into the SC-P9500 Series
by loading the paper horizontally.
When loading cut sheets, insert the leading edge
until you feel resistance.
When loading poster board, insert the paper
until the trailing edge is below the loading mark
on the roll paper cover.
E
Press the Complete - OK buttons on the control
panel.
F
Check the media type.
U “Setting Loaded Paper” on page 30
Removing Cut Sheets/Poster
Board
While supporting the paper so that it does not fall, press
Paper loading information on the control panel, and
then select Remove. The paper is ejected.
SC-P9500 Series/SC-P7500 Series User's Guide
Basic Operations
29
To Next Page
Loading...
Need help?
General