A
Set the auto take-up reel unit Auto switch to Off.
Plug the power cord into an outlet and confirm
that the power lamp lights.
B
Turn on the printer.
C
Check that the roll paper is correctly loaded in the
printer.
D
Select Paper loading information - Prepare for
Take-up on the printer's control panel.
The paper is fed to the roll core.
E
Tape the end to the roll core.
Place tape (available from third-party suppliers)
at the center and then at the left and right ends.
F
Flip the Manual switch on the auto take-up reel
unit to Backward, and take up as much paper as
possible.
After wrapping the paper around the core,
ensure that paper around the core is sufficiently
loose.
G
Set the Auto switch to Backward.
Removing Paper from the Auto
Take-up Reel Unit
This section describes how to remove paper from the
auto take-up reel unit.
SC-P9500 Series/SC-P7500 Series User's Guide
Basic Operations
41
To Next Page
Loading...
General