Item Parameter
Heating & Drying
Heater Temperature Pre-heater/platen heater: 30˚C to 50˚C (86˚F to 122˚F)
After heater: 30˚C to 55˚C (86˚F to 131˚F)
Drying Time Per Pass 0 to 10 sec
After Heater Feed Mode 1, Mode 2, Off
Additional Dryer On, Off
Advanced Settings
Media Tension 0 to 40
Media Suction 0 to 10
Head Movement Data Width, Printer Full Width
Tension Measurement Periodically, Every Page, Off
Multi-Strike Printing Off, 2 to 8
Feed Speed Auto, Lv1, Lv2
Roll Type Printable Side Out, Printable Side In
Restore Settings Yes, No
Print Media List Print
Printer Setup
For more information on these items, see U “The Printer Setup Menu” on page 149.
Setting items and setting values marked with asterisks indicate the following printer models.
*1: SC-S70600 series and SC-S50600 series only supported *2: SC-S50600 series only supported *3: SC-S30600 series
only supported *4: SC-S70600 series only supported
Item Parameter
Side Margin(Right) 3 to 25 mm (0.12 to 1.00 inch)
Side Margin(Left) 3 to 25 mm (0.12 to 1.00 inch)
Print Start Position 0 to 800 mm (0.00 to 32.00 inch)
Media Size Check On, Off
Media End Check On, Off
Media Skew Check On, Off
Head Strike Warning
*2
Warning Options On, Off
Warning Level Options 1 to 5
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Using the Control Panel Menu
140
To Next Page
Loading...
