Epson SC-S70600 Series - Transport

E
Unlock the stand.
Release the caster locks on the left and right legs
and fully raise the adjusters.
F
Move the printer.
c
Important:
Use the casters on the dedicated printer stand
to move the printer indoors a short distance
over a level floor. They can not be used for
transport.
Post-Move Setup
After moving the printer, follow the steps below to ready
it for use.
A
Check that the location is appropriate for
installation, and set up the printer.
After setup, be sure to perform parallel
adjustment again.
U Setup Guide
If you do not have the Setup Guide, contact your
dealer or Epson Support.
U “Where To Get Help” on page 186
B
Plug in the power cables and turn the printer on.
U Setup Guide
C
Perform a nozzle check to check for clogged
nozzles.
U “Printing nozzle check patterns” on
page 128
D
Perform Auto Media Adjust in the media
settings, and check the print quality.
U “Auto Media Adjust” on page 85
Transport
Before transporting the printer, contact your dealer or
Epson Support.
U “Where To Get Help” on page 186
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Appendix
177