Epson SC-S70600 Series - Take-Up with the Printed Side Facing in

Take-up with the Printed Side
Facing In
A
Cut the paper tape approximately 60 cm in
length, and paste it approximately in the center of
the media using commercially available adhesive
tape.
B
Hold down the u button until the tip of the tape
reaches the center of the pipe.
C
Turn the paper tape over from the front of the roll
core, and stick using commercially available
adhesive tape.
c
Important:
Attach the media to the take up roll core with
the media in a taut state. If media is attached
in a loose state, the media may move around
during take-up.
D
Flip the Auto switch to .
E
Lower the tensioner until it slightly touches the
paper tape.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
76