Epson SC-S70600 Series User Manual

N
Insert the media approximately 30 cm into the
opening, then lower the media loading lever.
O
Check that the edges of the media pass within the
dimensions of the square that was adjusted in
Step 5.
Example of setting media with a width of
64 inches
c
Important:
Perform Steps 14 to 5 in reverse order and
repeat the loading process if the edges of the
media are not within the square holes. Do not
attempt to reposition the roll holders while
they are inserted in the media.
P
Hold the center of the media and raise the media
loading lever.
Q
Pull the media straight to the center of the after
heater.
❏ Do not pull the media with both hands. This
could cause the media to skew or move
around.
❏ The labels on the after heater are not used
when media is loaded. If it is adjusted to
forcefully, the media way move around or
become loose.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
48

Epson SC-S70600 Series Specifications

General

Brand	Epson
Model	SC-S70600 Series
Category	Printer
Language	English