D
Cut the media with the cutter.
Pass the blade of the cutter down the cutting
groove.
When the auto take-up reel unit is used, proceed
to Step 5.
Otherwise, proceed to Step 7.
E
Set the Auto switch to OFF. Take up the cut
media completely by operating the Manual
switch according to how the media is rolled.
F
Remove the take-up roll.
U “Removing the Take-up Roll” on page 81
G
To remove the media, reverse the steps you
followed to load it.
U “Loading Media (SC-S70600 series, SC-
S50600 series)” on page 37
U “Loading Media (SC-S30600 series)” on
page 51
c
Important:
To finish the procedure in the SC-S70600
series or SC-S50600 series, raise the media
loading lever. Otherwise, the pressure rollers
will be deformed.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
66
To Next Page
Loading...
