Epson Stylus C50 - ASF Unit Removal

EPSON Stylus C50/C60/C61/C62 Revision C
Disassembly and Assembly Disassembly 101
4.3.5 ASF unit removal
1. Remove the Upper housing from the printer. (Refer to Section 4.3.1)
2. Remove three screws (C.B.S. SCREW 3x6 F/Zn, C.B.S-TITE (P4) 3x6 F/Zn,
C.B.P-TITE 3x8 F/Zn) for securing the ASF unit to the Main frame, and remove
the ASF unit with pulling up slightly to the backside of the printer..
Figure 4-20. Screw position for removing the ASF unit
3. Remove the Compression spring 2.50 located between the ASF frame and the
Hopper, and remove the Hopper from the ASF unit.
Figure 4-21. Compression spring 2.50 and the Hopper removal
4. Remove the Torsion spring 29.1 from the bottom of the ASF frame and the Pad
holder (Paper return plate).
Figure 4-22. Torsion spring 29.1 setting position
C.B.S. SCREW, 3x6, F/Zn
C.B.P-TITE, 3x8, F/Zn
C.B.S-TITE (P4), 3x6, F/Zn
Pad holder
ASF frame
Compression spring 2.50
ASF hopper
Torsion spring 29.1
ASF frame