EPSON Stylus C50/C60/C61/C62 Revision C
Disassembly and Assembly Disassembly 119
4.3.11 Caution regarding Ink system removal, PF roller
unit removal and PF motor removal
In case that you remove or replace the Ink system (Cap unit & Pump unit),
the PF roller unit and PF motor, we recommend to replace with new Printer
mechanism with the Lower housing.
This is because the Main frame may be transformed and the product quality
may be lowered when these parts is removed (or replaced) from the Printer
mechanism without the Lower housing.
Adjustment after replacing the Printer mechanism
When removing or replacing the Printer mechanism with new one, the
following adjustment must be performed in the order below.
1) Drain ink counter reset
2) Gap adjustment (Bi-d adjustment)
3) Top margin adjustment
4) 1st dot position adjustment
In case that you perform the operation with Printer mechanism without the
Lower housing in the urgent case, the procedures from the next page should
be followed surely.
However, the Ink system (Cap unit & Pump unit)/PF roller/PF motor is not
separately established for the after service part.
To Next Page
Loading...
