EPSON Stylus C50/C60/C61/C62 Revision C
Disassembly and Assembly Disassembly 111
CHECK
PO INT
When removing the Main board shield plate from the Main
board, pull the part indicated below vertically and remove it.
Figure 4-44. Main board shield plate removal
Pull
When assembling the M/B mounting plate to the Main frame,
Slide the hooks on the M/B mounting plate in the order
indicated in the following figure.
Figure 4-45. M/B mounting plate assembling
Fasten four screws (C.B.S. SCREW 3x6 F/Zn) for securing
the M/B mounting plate to the Main frame
Tightening torque for each screw is as follows.
•
C.B.S. SCREW, 3x6, F/Zn (1 pcs)
: 9 ± 1 kgf.cm
When assembling the Main board to the M/B mounting plate,
Make sure to set it to the M/B mounting plate correctly.
Do not touch the LED on the Main board
1
2
3
4
C.B.S. Screw, 3x6, F/Zn
To Next Page
Loading...
