Epson Stylus C79 - Procedures Specific to Epson Stylus C58;C59;ME 2

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21 Revision E
DISASSEMBLY/ASSEMBLY Procedure Specific to Epson Stylus C58/C59/ME 2 64
Confidential
4.6 Procedure Specific to Epson Stylus C58/C59/
ME 2
4.6.1 Printhead
 Part/Unit that should be removed before removing Printhead
Upper Housing /Hopper
 Removal Procedure
 Printhead Removal
1. Unlock the Carriage Lock with a flathead screwdriver or a similar tool, and
move the CR Unit to the center of the printer.
Figure 4-81. Releasing Carriage Lock
2. Open the Cartridge Cover and remove all the Ink Cartridges from the Carriage
Unit.
3. Follow the steps below to remove the Cartridge Cover Hinge.
(1) Cut off the part of the Cartridge Cover Hinge with a nipper as indicated in
the figure.
(2) Remove the upper part of the Cartridge Cover Hinge.
(3) Release the tab and remove the lower part of the Cartridge Cover Hinge.
Figure 4-82. Removing Cartridge Cover Hinge
4. Remove the Cartridge Cover.
5. Remove the screw, and remove the Sub FFC Guide while releasing the tab.
Figure 4-83. Removing Sub FFC Guide
Carriage Lock
CR Unit
Locked
Unlocked
C H E C K
P O I N T
The Cartridge Cover Hinge cannot be reused.
Cartridge Cover Hinge
Cut here
Tab
Lower part
Upper part
Sub FFC Guide
C.B.P 2.5X8 (Torque: 3±1Kgf.cm)
Tab