Epson STYLUS CX3650

EPSON Stylus CX3500/CX3600/CX3650/CX4500/CX4600 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 81
Table 3-3. Error Indications and Fault Occurrence Causes
Printer Status Communication error Ink low PG error Index sheet error (Incorrect card)
Indi-
cations
Power — ———
Error — — Blink 2 Blink 2
Ink — Blink — Off
Memory Card
(only for Stylus
CX4500/CX4600)
1 — ———
2 — ——Blink 2
3 — ———
7-seg. — — “H” blink 2 “4” blink 2
Paper Type
1 — ———
2 — ———
Paper Size
1 — ———
2 — ———
Fit to Page — ———
Card Access — ———
Status monitor 3 message — —
Fault Occurrence Cause
This error is detected when the SPC
cannot communicate with the PC
correctly.
This error is detected when the ink
consumption amount reaches about 90%.
Note :
Even if this error is indicated on the STM3,
you can continue the printing until I/C
becomes Ink Out condition. However, the
Head Cleaning operation cannot be done so
that the remaining ink is low condition.
This error is generated by PG large
condition and is detected at pressing of
BW/Color Start Switch when about to
use stand-alone printing.
(The PG error is not generated when
printing from a PC.)
This error is detected when the content
of Index Sheet and content of Memory
Card do not match.
(Checksum does not match, etc.)
Note : “–” : Don’t care
Blink : 0.5sec. On + 0.5sec. Off repetition
Blink 2 : 0.2sec. On + 0.2sec. Off + 0.2sec. On + 0.4sec. Off repetition
Blink 3 : Blink on and off along with access to a memory card.
Fast blink : 0.2sec. On + 0.2sec. Off repetition
Slow blink: 2.0sec. On + 2.0sec. Off repetition
Note *1: When the setting is “On”.
*2: After finishing copying, the counter returns to the preset number of copies.