Epson Stylus Photo R220 - Page 39

EPSON Stylus Photo R220/R230 Revision A
TROUBLESHOOTING Unit Level Troubleshooting 39
During operation
-
The paper is stained with the ink.
Frame EJ Assy.
1. Check if there is any ink adhesion on the Frame EJ Assy. 1. Clean the ink adhesion on the Frame EJ Assy.
with a soft cloth.
1. Check if the Frame EJ Assy. has not warped upward. 1. Replace the Frame EJ Assy. with a new one.
Paper Guide, Front
1. Check if there is any ink adhesion on the Paper Guide,
Front.
2. Check if the porous pad of the Paper Guide, Front has not
detached.
1. Clean the ink adhesion on the Paper Guide,
Front with a soft cloth.
2. Reattach the porous pad.
Roller EJ Assy.
1. Check if there is any ink adhesion on the Roller EJ Assy. 1. Clean the ink adhesion on the Roller EJ Assy.
with a soft cloth.
Paper Guide,
Upper
1. Check if there is any ink adhesion on the Paper Guide,
Upper.
1. Clean the ink adhesion on the Paper Guide,
Upper with a soft cloth.
PF Roller
1. Check if there is any ink adhesion on the PF Roller. 1. Clean the ink adhesion on the PF Roller with
a soft cloth.
Ink System
1. Check if the wiping operation has been performed
correctly.
1. Replace the Ink System with a new one.
Print Head
1. Check if there is any ink adhesion on the Print Head
Cover.
1. Clean the ink adhesion on the Print Head
Cover with a soft cloth.
The upper edge of the paper gets
creased.
ASF Assy.
1. Check if the Hopper Pad is stuck to the Hopper correctly. 1. Replace the ASF Assy. with a new one.
Table 1-26. Check Points for Print Quality Problems
Occurrence
Timing
Position of CR
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy